Fiber Optic Jumper Solutions

According to the different environmental requirements, we can match a variety of sheath (PVC, PVC, low smoke non-halogen flame retardant, etc), different network requirements, you can mix different types of fiber end face (PC, APC, UPC).

So in description a article fiber jumper, it needs to transmission type (single-mode, and more die), and ends connection manager type (ST, and SC, and LC, and FC, and MTRJ,), and end surface structure type (PC, and APC, and UPC), and core number (single core, and more core), and length (1 m, and 2 m,), and nurse sets flame retardant degrees (General, and low smoke no halogen), while light including support LED light and laser light.

Shenzhen Flachfiber’s BW-G fiber 10GBase-SR support for low cost and high performance serial transmission technology, supports the use of least-cost light-850 nm light, electronic devices, as well as the use of such light sources, transmission can reach distances up to 300 meters or more. Shenzhen jassonfiber BW-G fiber optic patch cord enables fast connection-SC connector and miniature optical fiber connector MT-RJ.

SC connector compatible with existing optical fiber distribution frame, support LightCrimp technology, by mechanical crimping method fixed optical fiber, without glue and sanding, field-simple and rapid installation.

Just after 3 simple steps: stripping cable jacketing, split and broken fibers and crimping, which can be completed in one minute all the termination process.

BW-G fiber optic connector can be applied to the buffer 250 μm in diameter and 900 m of fiber-optic cable and the cable jacket for 2.5mm or 3mm.

And the connection attribution specification test is fully consistent with and exceeds TIA/EIA-604-3 requirements,Using gray appearance, with the traditional connector differences.

MT-RJBW-G size only SC connector dual-port connector half, smaller than a standard RJ-45 connector, it can offer 2-core optical fiber termination and plug-adapter-plug design to provide more accessible and easier to clean fiber port. No glue/Polish-free guarantee faster termination.

MT-RJ is the active device manufacturers most likely to accept the SFF designs.

Single connector design can accept buffered and jacketed fiber. At the same time, Shenzhen Flachfiber optimized for Gigabit tomeet 10G Ethernet application.